That's cool Stone. Is it light tight enough?
Well, the initial design that I was going for would certainly have been like tight, with a double wall, however unfortunately this is part of the MSA which was due on the first, and without discussing it in detail, I was unable to access APUG until the first, and only found out that I would even be able to do that on the day before, so I build this in a rush and only had so many Legos to play with, and also I had the little one in the background and so as I said someone else I think I couldn't exactly take her pink Legos because that would not go over so well so I had to work with the materials at hand, so it became a fixed Focus box camera rather than a focusable Lego camera, and also meant that it would only have a singlewall rather than a double, which allows for cracks within the Lego pieces for like to get through. I was certainly aware that this is going to happen at the time, and just figured it was for fun and so I just took two send pictures the first of which was very not like tight and had a lot of streaking, and the second wasn't awful, but unfortunately I couldn't go back enough with the camera sitting on the table and didn't have enough time or Legos to build it farther from the focal point of the Polaroid film I was using, so I knew that the image was going to be a little bit blurry, but it was all for fun so I did it anyway here's the image, I stopped down as much as I could and still have a one second exposure which was the longest that I could get the little one to sit still for as well as the person aiming the camera wouldn't be able to do a bulb exposure properly. If I could have stopped it down to say f/45 I certainly would've had a much clearer image but just didn't have the time for that.
The first light leak exposure
The second less lightly exposure