He surely knows that because his ISO film speed was set at 6400 and he observed the sequential change shutter speeds in accordance with that number of exposure stop changes
What is the evidence that stand development in any developer cannot give such a push. Is there a limit to pushing for stand that does not apply to "normal" development and if so what is it and is it based on actual trials or are you saying that the limit to pushing applies to any developer even if normally agitated?
Leaving aside Pyro 510 if I may for a moment, for which 1 + 100 is normal and turning to say Rodinal which at 1+100 is highly diluted the answer surely is to ensure that the minimum developer amount is met for 1 film which may be 5ml then does the dilution matter? I'd have logically thought not
I now note that you agree the OP did shoot at 6400 but I was composing my reply while you had already replied on this point My other questions are I believe still valid
Thanks
pentaxuser
I stand (no pun intended) corrected if 1:100 is normal dilution with 510-pyro. 1:500 would be a rough equivalent to rodinal/HC-110 1:100/1:119 ?
Regarding rodinal that I do know, my understanding is that at 1:100, after an hour stand the developer is exhausted (or nearly exhausted), so prolonging the time does next to nothing. On the other hand, I recall now a photographer saying that he left by mistake a roll the whole night and it came out very dense, so maybe it's not as inactive as I thought. Maybe it's possible to push one or two stop with this, but four ??