The camera is now ready for use and loaded with a Kodak Ektar 100. Two problems had to be solved:
- extreme friction when cocking the shutter
- incorrect and irregular shutter speeds.
How did I do it? The aim was to open or dismantle the camera as little as possible so as not to damage the shutter blades and avoid loosing the adjustment of the lens.
First of all, pulling the camera apart and pushing it together had to be made easier. However, you can only access the sliding surfaces in question if you dismantle the housing, i.e. dismantle the bottom shell, front side and operating side. However, because of the problems described above, this was out of the question.
Instead, I carefully applied lighter fuel to the horizontal gaps where the housing parts slide together. I had to be careful not to let too much of it get into the camera at once and possibly leave marks on the lenses. This required some overhead work to keep the liquid flowing away from the lens. Ultimately I was able to loosen the sticky lubricant film and partially remove it with a very fine interdental brush. The rest could be pushed off the sliding surfaces by pulling the camera apart and pushing it together several times in such a way that the friction was significantly reduced. After that, the operation was smooth enough to work with the camera. This compromise made it possible to avoid completely dismantling of the camera.
With regard to the shutter speeds, it was suspected that the pivot points in the escapement were difficult to turn due to resinification. The escapement on the Minox is easily accessible via the upper end cap, which is only attached with two screws (in the middle the flash contact):
A look inside shows that the mechanics are in very good condition. You can see how dust-tight the housing has protected the interior for 70 years. At the top edge of the case you can see exactly how far the dirt has made it. The aluminum profile of the cover plate acts as a labyrinth seal - without any rubber:
By patiently applying small amount lighter fuel to the bearings and gears, alternating with shooting at the slow shutter speeds, the movement became smooth again. Since then, times have been running plausibly and consistently again. The video gives an impression of it:
.
The last thing I noticed was that the connection between the adjustment knob and the time disc had come loose.
This could be fixed with a little courage and superglue between the time disc and the setting button:
