Repair manual for CPE-2Plus

[mshchem]

I cleaned every thing. Heater works and temp censor works.
Motor spins one direction.
Lift works well just needs a gear between the CPE-3 and the lift.
Where can I find that gear? See picture bellow?
View attachment 341266

Can you show a clear picture of your machine? My CPE2 Plus and my CPP3 have a motor drive gear that is black nylon. This black gear drives either 1 or 2 (CPP3) White nylon gears on the lift that in turn drive the tank gear.

If you are in the USA Catlabs in Jamaica Plains Massachusetts are your best bet. The drive cog is usually supplied with the lift. May be Ebay would work??? There's a straight shaft and a tapered shaft motor, I believe that the CPE2 Plus is the straight but I'm not sure.
I would start with Catlabs, ask for Jobo service, be patient.

 

[mshchem]

Here's transfer gears for the CPP3 machine. You need to call about your gears

Jobo Pair of White Transfer Gears for Jobo Lift (#95200)

• Brand new • Replace your transfer gears and keep them lubricated • Making sure your transfer gears are in good shape and well lubricated will...

www.catlabs.info

 

[mshchem]

One other thought, reach out to Fotoimpex in Berlin, they sell Jobo, I suspect it would be a simple phone call for a place like Fotoimpex to get the correct repair parts. If you're in N America start Catlabs

 

[mpirie]

You don't need magnets if you want to use the lift. You need cogs on the tank lid and on the drive motor.

You're right of course, i missed the references to the lift.

Mike