There's a thermal over temp breaker switch that trips out. The switch on the left side of the unit, is reset with a pen or pencil etc (hole is on the side). This can be accidentally tripped when cleaning with hot tap water, or just momentarily turning on the unit without water.
Look at Jobo USA for manuals etc. Catlabs is the service center in USA
Yep. Will try that.
Thanks
So does the motor run if power is on and motor is switched to on? The little light is illuminated when heater is on.
No light no noise.
Maybe I have to fill it with water for it to start?
I would definitely be returning that POS.
Honestly if can I rather save it.
The leak is not a big deal. A little epoxy and/or duct tape. Any connection with corrosion needs to be cleaned up with a fine brass wire brush. Could be a stuck relay maybe tap gently with the handle of a screwdriver.
I'm hoping you have the drive cog? I would get the leak patched on the inside with a bit of tape, fill up the trough and confirm it heats. If that works you are in business.
1500 series film tanks will work fine even if you can't get it to reverse, not print drums you will have streaks.
I would confirm heat. Then start cleaning terminals. UNPLUGGED. When you are testing don't be standing in water and become a lighting rod. It's amazing how much current the human body will carry if well grounded
Got partial refund . The lift is ok
It heats up and comes with extra heating element.
I am missing a gear. But overall happy with the purchase.
Just have to find a way to clean it good.
Be careful, could be that the heating element melted the bottom of the trough. Factory has little ceramic spacers, just be careful
Good, you are halfway there. Do you have any tanks? The little rollers etc. Take a couple pictures of what you have.
And regarding developing film. I have a Jobo Duolab, using the 1520 tank it works great, only spins in one direction, color or black and white, no problem.
I would start by cleaning corrosion, very gently on the wire terminals. Try wiggling the wire connections, could just be corrosion. Absolutely be careful with electricity!
Will do. I have Jobo tanks but not cog. Also i think one gear is missing on the CPE-2plus:
Might try the magnet first.
View attachment 341219
Definitely need the drive cog. Not sure why it has a lift but no cog? Did you get a round magnet? Magnet is how tank is driven without a lift
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?