rorye
Allowing Ads
OK, I was debating painting my ratty old 200. Having seen that photo I'm off to the hardware store. Thanks for the inspiration!
Where did you get the foam rubber? Mine is starting to go....
While the top heating part was out I took the opportunity to repaint it also. I used silver 'hammer-metal' finish paint. So here it is BEFORE and AFTER:
ic-racer inspired me to take a shot at restoring a Seal 200 Commercial that I bought on Craigslist. Here it is, still waiting on a new pad from B&H and some high temp wire to complete rewiring it.
View attachment 61352
It looks as if you have a brand new press. Did you replace the heating elements also? Now how much is the hernia operation going to cost from lifting that monster? I have a hernia and don't dare lift my press and it is much smaller that yours.....Regards!
Rustoleum Hammerd finish. I used 'paint prep' from the auto finish store.Beautiful job. What paint did you use? ...and just as important, how did you clean it up before painting it?
I met up with the seller at a photo meet. We lifted it together to my car. When home, I disassembled it to get it out of my car and into the basement piece by piece.It looks as if you have a brand new press. Did you replace the heating elements also? Now how much is the hernia operation going to cost from lifting that monster? I have a hernia and don't dare lift my press and it is much smaller that yours.....Regards!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?