Huss
Member
Hello, new member here needing help! (And I promise to stick around and be a participant.)
So I've been playing with my FT2 which I just 'won'. I thought it may have a jumpy meter, but in fact it is very consistent. But still has this one issue..
For some reason when I select a shutter speed of 1/4 sec or slower, no matter the aperture, the meter shuts off. The needle immediately moves to the off position, even if the 1/8 speed setting (or faster) was showing an active reading.
I can take the lens off the camera, and same behavior. With no lens, the moment the shutter speed is 1/4 sec or lower the meter turns off.
Any helpful suggestions apart from send it back? Would a cleaning of certain bits and pieces help? And if so, what would those be?
Thanks
Best regards
Huss
So I've been playing with my FT2 which I just 'won'. I thought it may have a jumpy meter, but in fact it is very consistent. But still has this one issue..
For some reason when I select a shutter speed of 1/4 sec or slower, no matter the aperture, the meter shuts off. The needle immediately moves to the off position, even if the 1/8 speed setting (or faster) was showing an active reading.
I can take the lens off the camera, and same behavior. With no lens, the moment the shutter speed is 1/4 sec or lower the meter turns off.
Any helpful suggestions apart from send it back? Would a cleaning of certain bits and pieces help? And if so, what would those be?
Thanks
Best regards
Huss