Eyecup for Fuji GW670II

[Carterofmars]

I need a Eyecup for the Fuji GW670II.

Any leads appreciated.

 

[MTGseattle]

"old" Nikon DK-4. If you can find the exact thread diameter and pitch, you may be able to figure out if the newer (DK-19) series ones will fit.

 

[mshchem]

I need a Eyecup for the Fuji GW670II.

Any leads appreciated.

I have a GW690II, the thread of the eyepiece matches the original, not HP, Nikon F3 prism finder, I use one of Nikon's, available on Ebay, rubber clad eyepiece. It's not an eye cup but it prevents the camera from scratching my glasses. On Ebay what I use is referred to as the Nikon 2923. The last five digits on the box barcode is 02923, I think this is the same diameter/size used on the F2 series and the later F prisms. I have these eyepieces on several cameras. Getting scarce but there still around.

 

[250swb]

Yes the F, F2, or F3 (but not the HP) eyepieces are interchangeable so it should be easy to find an eyecup. I use a Nikon plain rubber eyepiece on my GW670 to stop my glasses getting scratched. The thinner F and F2 rubber eyepieces are getting scarce but the thicker F3 version does fit them.

 

[Arcadia4]

One like this fits fine;

Nikon Eyepiece for FM3a, FM2 FA, FE2 etc ~ Brand New Genuine Part - Nik & Trick Photo Services

Here is that elusive part! A lovely finishing touch to your lovely Nikon and a MUST have for people that don't want to scratch their expensive glasses. Brand new genuine Nikon part (RRP is over £32 via Nikon dealers)

ntphotoworks.com

 

[OAPOli]

I'll add that I use a DG-2 magnifier on a GW690III, same threads as above suggestions.

 

[250swb]

I'll add that I use a DG-2 magnifier on a GW690III, same threads as above suggestions.

And the DR-3 right angle viewfinder, it's very useful on the Fuji rangefinders especially if the camera is low down on a tripod, saves achy knees.

 

[Carterofmars]

Thanks all.