Emptying large trays.

[gordrob]

I have been agonizing over emptying big trays and the siphon is a good idea, where did you get yours. I have to get one.

I have two of these - one for emptying the gas in the lawn mower at the seasons end and one for the darkroom. Runs on 2 D cell batteries. I got mine at Princess Auto. Here is the link

https://www.princessauto.com/en/12-gpm-battery-operated-pump/product/PA0008555765

[/URL]

 

[eli griggs]

A large sheet of plexiglass (or other ridged sheet good), pain into into the developing tray, with chemical, which rest on it when allowed, but otherwise floats above the bottom, could also use rust proofed bankers 's clips at the far, wide paper 's margin, could keep paper flat, for thin or exlarge sheets or transferring to other trays, or a 'waterfall' washing setup, even an archival washer tank, might serve some well.

I have some large trays, but a small space in which to work, so I might give this a try,maybe, but I'll bet tears wrinkles and folds would be a rare thing!

 

[DREW WILEY]

Large trays were once available with drain valves. These can be added afterwards, but need to be the right kind, with a gasket system able to seal even holes in polyethylene trays. Scientific supply houses carry these.