Want to Buy WTB copal 0 lens board for graphic view II 4x5

[jameswilliamjones]

Looking for an original copal 0 lens board for a graphic view II 4x5 view camera. The one I have is copal 1 and is a molded metal painted grey-silver. Needs to fit my Nikkor SW 90 f/4.5. Thanks for your help.

Also still looking for a jobo lift cog for a straight drive shaft CPP2 processor.

Thanks all!

JamesWilliamJones

 

[L Gebhardt]

A 4"x4" piece of 1/4" plywood makes a fine lens board for the Graphic View II if you can't find the real thing.

 

[removed account4]

you might need the recessed board for your 90mm lens.

 

[illumiquest]

PM sent, I have a recessed and a flat both with Copal 0 holes. They're black if that makes a difference.

 

[Fotoguy20d]

you might need the recessed board for your 90mm lens.

No might about it. I have the 90mm f8 Nikkor-SW - it won't focus without the recessed board.

 

[ic-racer]

Per the Graphic view manual, under ACCESSORIES: "#9234 Recessed Board for the 90mm"

Also:

"For Wide Angle photography the front and rear standards are both placed ahead of the pan-tilt camera support clamp to provide a clear vield of view. The accessory recessed metal lenmsboard permits the use of modest adjustments of the swings and tilts even with a 90mm wide angle lens."

 

[jameswilliamjones]

Thanks everybody for your help. I'm glad I didn't try to buy a flat board. That would really ruin a good afternoon with the camera. Nice pictures ic-racer! Any of those for sale? This recessed-lens-board talk makes me think I've got too much lens for this camera. Is there one better?

 

[ic-racer]

I've got too much lens for this camera. Is there one better?

Back 'in the day' the Optar 90mm was a fine lens for this camera. But kind of dim with a small image circle compared to your Nikkor. If you don't like the Nikkor you can always sell it and buy five of these:

 

[jameswilliamjones]

ic-racer, that sure looks a lot smaller than the one I bought below. You think it will fit?

 

[illumiquest]

That's certainly a lot of lens for a camera... Here's a 72mm f/5.6 XL on my Busch Pressman. Definitely well hung

 

[ic-racer]

I think the shutters on the two lense are about the same diameter. Hey if it doesn't fit you'll just have to get a Walker Titan XL 45

Another thing is that your flange-focal-length is 97.4mm, so that Nikkor is slightly recessed (7.4mm) in the shutter already. Measure you camera from lensboard opening to ground glass (with a ruler through the lens opening on your lensboard) and see if it will squeeze down to 97mm.

 

[Fotoguy20d]

I have the Nikkor-SW 90mm f8, which is a bit smaller than your lens, but also in a Copal 0. It's a tight fit inside the smallish bellows of the GV-II and you won't be able to get much movement. It's a shame when you have a lens that can cover 5x7.

My GV-II came with the Optar 90mm f6.8 in a recessed board. It's a quite respectable lens although won't cover much more than 4x5 so movements end up a bit limited. I've also used a 90mm f6.8 Angulon, which is little different from the Optar.

I think I have a spare recessed board, but I believe it's drilled for a Copal 1. I'll check later.

Dan

 

[jameswilliamjones]

Hey Illumiquest, that's a pretty big lens. And shooting that wide you can gurantee the rails are going to consume the bottom third of your negative.

 

[jameswilliamjones]

Dearest friends, please meet the Walker Titan XL 45.

I measured my camera. I need a 4" x 4" board. The camera is 8 cm from board to ground glass fully collapsed. Looks like I need a recessed one. SK Grimes does not appear to have graphic recessed boards...at least online they don't. I'm assuming copal 0 is 34.7mm (35mm?).

 

[Deleted member 19578]

Recessed board?

I have a 4" x 4" board that is recessed 1.25" with a Copal 0 (35mm) opening:

$30 shipped (48-US)

 

[jameswilliamjones]

John,

Literally minutes before your post I purchased one from KEH. I think I might need a 32mm. Let me see if that fits and if it doesn't I'll get back to you on this one.

Thanks for the offer!

 

[Deleted member 19578]

Okay- It's sitting in the cabinet... waiting, abandoned, unused, forlorn, lonely, bereft.

 

[ic-racer]

That Walker is nice but the camera you may want to match your new lens is this one (the XL Wide):

 

[jameswilliamjones]

That's nice. I want one. Let me check my bank account.

Yep! Still empty.

 

[jameswilliamjones]

The lens board from KEH is going to work. Getting to the controls on the shutter is tough. I have to use a pen to adjust the aperture and am waiting for a 90 degree release cable. The important thing, mobility of the front standard, is still good. Looks like it's gonna be a good summer with this camera.