Spot before ar after drymounting?

[Pasto]

Can spotting be done before dry-mounting an FB print? Is there a logical sequence?

 

[Mainecoonmaniac]

Don't know if it makes a difference, but I spot before. I think mounting the print then spotting makes the print harder to handle. I don't think heat will effect spotting dyes.

 

[tkamiya]

I actually spot before developing the image.... (just kidding)

I also spot first. If I mess it up, I'm not wasting an expensive backing paper. Heat does not affect spotting dyes. Also, smaller size of paper helps me handle it better. I wear a white dust free cotton gloves while doing this, so that I don't contaminate the print. Works for me.

 

[Bob Carnie]

the gelatin will absorb the dyes better before hot mounting. But you can do both

 

[Gadfly_71]

I spot (when I absolutely have to) before dry mounting. If I screw up the print it's easy enough to do another one, but if it's mounted then I'm not only out a print but I've pretty much hosed a mat board too.

 

[Pasto]

Since I started using a glass carrier (thanks to Mr. Carnie ) I'm finding that spotting is pretty much a necessity no matter how careful I am. I think your suggestions are very reasonable (i.e., spotting before mounting) for all the reasons stated. Off to learn how to do it well.....