Rives BFK Velin for pt/pd

[eggshell]

Hi,

I just bought a sheet of Rives BFK Velin. Looks a little rough on the surface. Is this different than Rives BFK vellum? The last time I read here, it should be soak in 1%-2% OA for 5 min, single coat, blow dry, rehumidify before printing. Is this right info? Thanks!

 

[donbga]

Hi,

I just bought a sheet of Rives BFK Velin. Looks a little rough on the surface. Is this different than Rives BFK vellum? The last time I read here, it should be soak in 1%-2% OA for 5 min, single coat, blow dry, rehumidify before printing. Is this right info? Thanks!

That should work fine, I soak for 10 minutes and interleave the paper carefully to keep from roughing up the paper. Hang to dry.

Ideally your coating area will have the proper humidity. Leave several sheets for a printing session out to reach ambient humidity. Coat. Blow dry briefly after letting the sensitiaer set for a minute. Rehumidify the paper. You can do this by letting the paper sit for about 30 minutes or so in you coating area with the lights out or by using a humidifier.

 

[eggshell]

Hi Don,

Thanks for the reply. I made a print today. Very nice paper. Easy to handle and good blacks. Less expensive too. Hmm... I like it already! Now I can throw away the platinotype.

 

[donbga]

Hi Don,

Thanks for the reply. I made a print today. Very nice paper. Easy to handle and good blacks. Less expensive too. Hmm... I like it already! Now I can throw away the platinotype.

Now you are ready for gum overs!

 

[eggshell]

Now you are ready for gum overs!

Sounds good to me. But first, I'll have to reprint most of the photographs made previously on platinotype. Platinotype looks grayish, hazy and lifeless. Looks like s**t!

 

[Kerik]

Platinotype looks grayish, hazy and lifeless. Looks like s**t!

Don't say I didn't warn you...

 

[eggshell]

Don't say I didn't warn you...

Never doubted you. Thanks!