Replacement parts for Iford 400 controller?

[nixuser23]

Hi there,

I was wondering if anyone knew of a good source for the buttons / switches that are in the MG400 controller.

I came across one for free recently, but it looks like the expose and cancel buttons need a little help. It's way easier to solder parts in this than the 500C, so I'm not concerned if I can get actuators to fit. Of course, I'd much rather have a 500 or 600, but, well, free is free.

Thanks,
Don

 

[nixuser23]

And I apparently can't type today either. Iford.. Sheesh.

 

[MattKing]

Don:

I don't know whether this will help, but here are two wiring diagrams for the 400C that I was able to obtain through Ilford and their Canadian distributor, Amplis:

My 400C is working well, but if by chance you should come across a source for replacements for the lamps behind the push-button switches, I would appreciate learning about it.

Matt

 

[nixuser23]

Thanks Matt. That helps a bit. If I stumble across something, I'll definitely let you know.

Don