Removing mold inbetween a bonded front lens

forest bagger

Member
Joined
Nov 9, 2023
Messages
259
Location
Germany
Format
DSLR
Hello folks,

unfortunately it is a common problem that the front lens of the SONY RX10 fogs up from the inside, between the individual lenses, and then after a while becomes moldy because the bonding of the two lenses in the plastic frame is not completely tight.






Some years ago there were spare parts for this bridge camera like this front lens available, but today even used ones are not to find...
So I had to cut the rear lens out of the frame:




Clean everything thoroughly:




Glue the lens back in:




And after a day of drying time, reinsert the front lens:




The small scratches were of course not caused by me, they were already there on the outer lens surface...

 

Dan Daniel

Subscriber
Joined
Jul 4, 2009
Messages
2,883
Location
upstate New York
Format
Medium Format
Nice.

Did you do anything specific to get the lens to sit in its mount properly? Did it simply index back into place smoothly? Getting a lens element crooked always worries me.
 
OP
OP

forest bagger

Member
Joined
Nov 9, 2023
Messages
259
Location
Germany
Format
DSLR
Since I have no way to optically center a set of lenses, I reinstall a lens in exactly the same position as I removed it.
As you can see in the photos, I leave one of the seals uncut and mark the other two joints in the frame with a red felt-tip pen.
 

BrianShaw

Member
Joined
Nov 30, 2005
Messages
16,526
Location
La-la-land
Format
Multi Format
How did you clean the fungus so thoroughly?
 

Coins

Member
Joined
Nov 21, 2024
Messages
1
Location
Michigan, USA
Format
DSLR
I love your post! I just purchased an old RX10 inexpensively due to fungus. Your post is great! I do have two questions though:
1. Why did you remove the back lens instead of the front lens? It seems as though the back lens has some retainer tabs that the front lens doesn't have.
2. How did you apply glue to the lens when you replaced it?
 

xkaes

Subscriber
Joined
Mar 25, 2006
Messages
4,791
Location
Colorado
Format
Multi Format
I'm surprised that a case of fungus that severe does not seem to have etched the lens coating -- assuming that it is coated.
 
OP
OP

forest bagger

Member
Joined
Nov 9, 2023
Messages
259
Location
Germany
Format
DSLR
1. Why did you remove the back lens instead of the front lens? It seems as though the back lens has some retainer tabs that the front lens doesn't have.
Because the front lens is pressed firmly into the plastic housing. To cut it out is much more work and to get it in after the cleaning difficult. And getting this dense against moisture ist complicated.
2. How did you apply glue to the lens when you replaced it?
With a thin spatula.
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…