Possible light leak with Rollei 6008

[aca91]

Hello Apug,

I've been using a Rollei 6008 Integral for a while and I've been noticing spots on my film, but I don't know what they are. Any opinion would be appreciated, specially from someone with the same gear. I'm attaching and image which shows the problem.Thank you for your time.

 

[gone]

Doesn't look like a light leak to me. Are the spots always in the same place?

 

[TimVermont]

Check the laminar drawslide for damage. Also see this earlier post about trying to load under the clips: (there was a url link here which no longer exists)

Your sample image doesn't look like either of those things, but it can't hurt to eliminate them as possibilities.

 

[ic-racer]

Bubbles.

 

[itsdoable]

Bubbles.

Yes.

If it was just bright spots, it could be a light leak. But the dark spots tell the story. Processing.

 

[dehk]

Make sure you got enough fluid (developer) covering the film also.

 

[tnabbott]

I have two 6008i cameras. I have not seen this before. How do you process the film?

 

[aca91]

Thank you all for your replies. Normally I use HC-110 1+31, then stop bath, fixer, clearing bath, wash and hypo clear. The spots are always on the same place, if they were bubbles wouldn't it be a little bit more random?

 

[MattKing]

Carefully clean and scrub your developing reels. The bubbles may be forming where there is some residue adhering.