I just picked up a new Beseler 4x5" enlarger and all's well except no lens boards. I've got 3 lenses, all with 39mm threads, so it'd be great to get 3 boards with retaining rings or threads.
The lens boards need to be 4"x4".
Let me know if you have anything and we'll work something out.
thanks, I didn't think that it was going to be a used one, I will wait to buy it so I don't steal your deal. I doubt they have very many of those.
I didn't know about the one for 15 so I'm happy either way.
That's what I would buy and that's the enlarger I just got as well, or nearly the same. You can measure the lens board opening, and it might be hard to tell if you're measuring exactly the right area (since there's a little spring, and a recessed area), but if it's near 4", rest assured a 4"² board will work.
I tested mine with one of my 4x4" LF lens boards and it fit fine.
I have a 39mm ring that fits 39mm Leica thread. $6 including shipping to US address . robertshanebrook@yahoo.com If you email me I'll forward a photo of it.
Mr. Burger, I found two 4 x 4 inch lens boards in my basement. Each has the little plastic red tube that shows when the enlarger light is on. I had a Beseler 23C at one point, but opted for an Omega D2. I don't have any retaining rings, but I thought they always came with the lenses. If you need some, I can check with Midwest Photo (we're both in Columbus).
Hi, I found two 4 x 4 inch Beseler lens boards in my basement. They are very clean, and each has the little translucent cylinder that shows you when the enlarger lamp is on. I don't have any retaining rings; I thought they came with the lenses. If you need those, I can check with Midwest Photo; we are both in Columbus.
I used to have a 23C, but later switched to an Omega D2