What is the length of the bellows on a Miniature Speed Graphic?
Miniature Speed Graphic Bellows Length
-
A
- Thread starter MrBrowning
- Start date
Recent Classifieds
-
For Sale Yashica Lynx 14 and Lynx 14e.
- Started by Chan Tran
-
For Sale 4x5 film holders
- Started by Early Riser
-
Want to Buy Omega D5500 with Dichroic Head, Australia
- Started by andrewherrick
-
For Sale Two Graflex 6x9 film backs for Graflex RB 6x9 (2x3)
- Started by Alex Varas
Forum statistics
- Threads
- 199,021
- Messages
- 2,784,765
- Members
- 99,779
- Latest member
- Deezfluffybutternutz
- Recent bookmarks
- 0
Do you mean fully compressed or fully extended?
OP
OP
Fully extended.
From back edge of the front standard to the edge of the back is 7 inches. Pleat width is 1/2 inch. Allow 1/4 to 1/2 inch front and 1/8 inch rear for mounting. The bellows rear was factory attached with 1/4 inch long #22 gauge wire brads with flat heads that are no longer available. The bellows can be glued to the edge where they were previously tacked with the wire brads.
OP
OP
Thank you very much.
| Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links. To read our full affiliate disclosure statement please click Here. |
PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:  |