Mamiya 645 AE Prism Repair

[aoresteen]

My AE prism for my Mamiya M645 1000s camera is overexposing by 1 to 2 stops. Any recommendations on where to send it for calibration/repair? I want to use it with E-6 film but can't due to the errors.

I prefer a shop in the USA.

I contacted Mamiya but no response yet.


Thanks!

 

[anikin]

I had that happen on my PD prism. I ended up replacing one of the photodiodes which was cracked:

(there was a url link here which no longer exists)

I don't know where you could send it to for repairs though.

Eugene.

 

[Trail Images]

Try KEH.....

I tried MAC....Mamiya America Corp. about two months ago now for a similar repair and or new for an RB67 metered prim......after two emails and no response I gave up on them.

 

[aoresteen]

Try KEH.....

I tried MAC....Mamiya America Corp. about two months ago now for a similar repair and or new for an RB67 metered prim......after two emails and no response I gave up on them.

I gave KEH's Repair center a call. They do NOT work on the Mamiya M645 series of bodies & prisms. Lack of parts is what they said.

 

[aoresteen]

I called MAC (914) 347-3300 and spoke to them. They do not repair any cameras as they sold that part of Mamiya to the new company (Mamiya Leaf ) that does cameras. Mamiya Leaf does not work on any film cameras. They told me to contact KEH

 

[macfred]

I can remember an advice on photonet.com for Mamiya repair in the USA - Dead Link Removed - Dead Link Removed
Perhaps you can try to call Bob Watkins.

 

[Trail Images]

Hi Tony, sorry to hear they put you in a infinite loop between MAC and KEH. Too bad about KEH I was hoping they could help out, but if they cannot get the parts then that seems pretty final there.
As I went through a bit of this with my RB recently and finally bought a Excellent+ off the internet from Japan I'd be interested in how things go for you with any possible repairs from other vendors you might find. Good luck.

 

[aoresteen]

I can remember an advice on photonet.com for Mamiya repair in the USA - Dead Link Removed - Dead Link Removed
Perhaps you can try to call Bob Watkins.

Thanks for the tip. I sent him a an email.