Linhof Technika IV viewfinder question

wjmva · May 17, 2005

My viewfinder needs to be tightened so that it does not slip off the "shoe". Any ideas?

David A. Goldfarb · May 17, 2005

After mine fell off once, I tried to see if there was a way of tightening it, and I couldn't find it. I guess if it's really loose you could add a layer of tape to the bottom of the shoe to snug it up a bit.

shyguy · May 18, 2005

ok here is a thought. paint the bottom of the foot with clear hard nail polish. let it dry well and try it for fit. keep building up the polish until you get a more snug fit.

S.

John Koehrer · May 18, 2005

Or thin brass shim stock. Cut to size.
I've used thin wire bent to fit around back of mount & over front of camera.
Basically a "U" shape with small "feet" at the front edge.

wjmva · May 18, 2005

Solution found

I just replace the bellows on this camera and was feeling gutsy so I decided to remove "shoe" and found two tension springs underneath. I bent these a bit and reassembled. This did the job.

If anyone is going to try this to their Technika let me suggest that when you reassemble the shoe hold it upside down, place each spring in its slot, use a q-tip to put a dollop of grease or vaseline on both ends of the two springs. This will hold the springs in place when inverting and positioning the "shoe" on the body of the Technika.

MikeS · May 28, 2005

wjmva said:
I just replace the bellows on this camera and was feeling gutsy so I decided to remove "shoe" and found two tension springs underneath. I bent these a bit and reassembled. This did the job.

If anyone is going to try this to their Technika let me suggest that when you reassemble the shoe hold it upside down, place each spring in its slot, use a q-tip to put a dollop of grease or vaseline on both ends of the two springs. This will hold the springs in place when inverting and positioning the "shoe" on the body of the Technika.

Thanks! While my finder wasn't loose, it certainly wasn't tight either. It is now On my camera, there was enough grease already on the springs that I didn't need to add any to hold the springs when replacing the shoe.

jjstafford · May 28, 2005

wjmva said:
I just replace the bellows on this camera and was feeling gutsy so I decided to remove "shoe" [...]

Just curious - was there also another serial number under the shoe?

MikeS · May 30, 2005

jjstafford said:
Just curious - was there also another serial number under the shoe?

Not on my IV, no number at all under there.

-Mike

Linhof Technika IV viewfinder question

Moderator

Privacy & Transparency

Privacy & Transparency