After rinsing I squeegee the prints on a sheet of glass with a print wiper and place them in a tray at different angles [so they do not stick together when I take them out one at a time]. I then take the prints to another room and load them in to the print dryer.
Steve
Add or use a print roller ... Steve
What about instead of a sponge using ShamWow? Steve
Soak in Pakosol used at print-flattening dilution. Drain. Pat dry with cotton bath towel. Dry with an Arkay drier - usually face-to-canvas but sometimes face-to-ferrotype. Flatten in dry-mount press.
The Pakosol gives a nice 'hand' to the paper.
For RC, just pat dry with a towel and leave face up to dry on a new towel.
I use the sme dryer and I have never been able to face the print towards the ferrotype. How do you do that without the emulsion sticking to it?
Steve
I use the sme dryer and I have never been able to face the print towards the ferrotype [without sticking].
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?