JOBO CPE2 lift screws

[Kilgallb]

I was reading how to replace the white retainer clips on my recently acquired JOBO CPE-2 processor with a lift.

The instructions say to remove several Philips screws and pull the diverted out. But my processor has no screws so it just stays in place rather loose.

I would like to replace the screws. Does anyone know what size screw it is. The JOBO site has no parts list so I thought someone in APUG might know the answer. I am sure they are a plastics type, not a machine screw.

 

[Joel_L]

Does this help

Replacing the Retainer Clip of a Jobo Lift – Richard Man Photography

richardman.photo

 

[Kilgallb]

I used the same instructions, but all the screws in my unit were gone.

I ended up using a 1/2” #2 wood screw with a countersunk head.