Hpw many prints 15 x 20 cm I can develop in 1 liter Codak ectacolor SP Prime Lorr

[Sergejs Orlovskis]

Hpw many prints 15 x 20 cm or M2 I can develop in 1 litre Kodak ectacolor SP Prime Lorr developer

 

[darkroom_rookie]

Last liter of Tetenal's developer (that's mixed from 3 parts, and likely has a different replenishment rate than Kodak SP Lorr) was sufficient for 26 30x40 cm prints, developed in a 40x50 cm Jobo drum. As a starter (again, don't know if SP Lorr requires starter) I simply used around 30ml of the last batch of dev saved from the previous session. Halfway through the liter, I dump two thirds of the dev and mix the rest with fresh dev. I use 200ml for each print and mostly use drum's entire capacity, meaning I fill up the 4511holder as much as possible (e.g., one 30x40 + one 18x40 with two square enlargements). Hope this helps.

 

[markbarendt]

http://www.kodak.com/global/plugins/acrobat/en/service/chemicals/CIS278E.pdf

That might help a bit.

Most color developing systems are designed to be replenished, i make up enough to use in the tank or tray plus enough to keep the solution at normal strength during the planned session.