Going to try and fabricate a DDS head's Hex Cell Diffuser; can anyone take pictures of theirs?

[rpavich]

Well, after searching for the Beseler Dual Dichro S head's "Hex Cell Diffuser" and not finding one (except for the non-S model's) I've decided to see if I can fabricate the box that houses the aluminum honeycomb (the "hex cell" part of the the name.)

The non-S model's might or might not be smaller than the S model's because the hole that the light comes through for the non-S is smaller than the S model.

So what I'm wondering is if someone has the Dual Dichro S head would be kind enough to remove their Hex cell diffuser and take some clear pictures of it sitting next to or on a scale or ruler?

If anyone could that would be great.

This is the wrong one but it gives you the idea of what I'm looking for:

 

[rpavich]

After getting the manual for the S model it appears that they are the same size excet the S version has tabs that make contact with the circuit board underneath and cause the indicator light to go on.

Hopefully someone can verify this.

 

[rpavich]

Just in case anyone has one that they'd like to part with cheaply, here is a picture of the thing. It's the same except it's got the little tabs extending to close the circuit that lights the "diffuser" indicator light on the front.

 

[Premier]

Hi,
I know it has been a long time. Did you have any luck fabricating or finding a source for these "honeycomb" hex cells for the dual dichro S?
Thanks,
Phil