Anyone have a fix for this? the baseplate locks firmly to the camera, so no problem there. But the little key on the bottom won't stay in the 'up position', it flops around. Hoping not to have to tape up the bottom of my camera. Thanks!
Floppy key on M4-P baseplate
-
A
- Thread starter Joe Jesus
- Start date
Recent Classifieds
-
For Sale Halogen Bulbs
- Started by Peter Schrager
-
For Sale Chemicals for sale
- Started by Peter Schrager
-
For Sale Enlarging Lenses - Bundle of Three
- Started by jdart3000
-
For Sale Interest check on many items
- Started by campy51
-
For Sale FS: Toyo View - Linhof Technika Flat Lens Board Adapter
- Started by B.S.Kumar
Forum statistics
Anyone have a fix for this? the baseplate locks firmly to the camera, so no problem there. But the little key on the bottom won't stay in the 'up position', it flops around. Hoping not to have to tape up the bottom of my camera. Thanks!
Well, I've already fixed the issue. I emailed Youxin Ye for advice, and I'll share his response here for anyone with similar issues:
"This is an easy fix.
You need unscrew the screw inside the bottom plate, above the holding disc. Then you can disassemble the assembly. Slowly put parts in order, you will have to refit in the exact same order.
Then you can remove the ring with disc on the bottom.
You see a metal pin in goes through the key lower side, you need take off the pin. Then squeeze the key half ring, refit the pin back into place.
Reassemble the entire assembly, bear in mind the locking plate inside has a slot, when the key is folding down, the locking plate has a cut off, the cut off has to face the outside the bottom plate.
You will need apply small amount grease to the parts, so that the key after reassembly will work smooth."
"This is an easy fix.
You need unscrew the screw inside the bottom plate, above the holding disc. Then you can disassemble the assembly. Slowly put parts in order, you will have to refit in the exact same order.
Then you can remove the ring with disc on the bottom.
You see a metal pin in goes through the key lower side, you need take off the pin. Then squeeze the key half ring, refit the pin back into place.
Reassemble the entire assembly, bear in mind the locking plate inside has a slot, when the key is folding down, the locking plate has a cut off, the cut off has to face the outside the bottom plate.
You will need apply small amount grease to the parts, so that the key after reassembly will work smooth."
| Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links. To read our full affiliate disclosure statement please click Here. |
PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:  |