Dropping film... because I'm a clumsy klutz sometimes.

[Xmas]

Because then the photo-flo gets on the reels, and it is hard to get the residue (photo-flo plus gelatin) off the reels.

You also end up handling both the slippery film and the slippery reels when you go to hang the film to dry.

I also wonder if the reels themselves might prevent the photo-flo from acting evenly on the entire surface of the film.

Some of my reels are 55 years old are are not showing symptoms from an excess of photo flow.
When did you kiss the stone in Castle Blarney?

 

[Sirius Glass]

Some of my reels are 55 years old are are not showing symptoms from an excess of photo flow.
When did you kiss the stone in Castle Blarney?

You probably clean your reels and the rest of your equipment well after each use.

The last time I checked Blarney still cannot develop nor print film. Do you have a different experience?

 

[shoot6x7]

I develop my roll film negs on jobo reels, they stay on the reels until washing is complete. I then open the reel and dump the film into a bowl of water and photo-flo. The bowl is sitting on the floor of the shower. I reach in to the water photo-flo mix and grab the end. I attach a film clip and hang it in the shower. If I were to drop it, it would fall back into the bowl. I haven't dropped a roll yet.

Once hanging I wipe the roll and then attach another clip on the bottom.

For sheet film, the photo-flo mix is in an 8x10 tray and I attach the clip on the corner above the tray. So if I drop it ... it falls back into the photo-flo water mix.