Dev time for FP4+ using PyroCat-HD in tank

[Eric Rose]

I do not use tubes and never plan to. Searched the archives but can't find any times for FP4+ developed in PyroCat-HD in tanks. The preferred dilutions are 1:1:100, but will entertain others. Film is rated at 125 ASA. I print by enlargement on VC paper.

Any help would be appreciated. Also while I mainly do 4x5 I have about 6 rolls of minicam (35mm) stuff to develop too. Also FP4+. Do I use the same times??

Thanks,

Eric

 

[mikepry]

I'd love to know some starting times as well for fp4 in 35mm.

 

[Aggie]

ditto 120, as the 4x5 will be covered with Eric's question.

 

[Andy Tymon]

I asked Sandy King this question and he pointed me towards the unblinking eye article he wrote. He recommended a starting time of 9 minutes if you are using continuous agitation.I use this as my normal time for Fp4+@64 asa, for rotary processing.Hope this helps

 

[Eric Rose]

I asked Sandy King this question and he pointed me towards the unblinking eye article he wrote. He recommended a starting time of 9 minutes if you are using continuous agitation.I use this as my normal time for Fp4+@64 asa, for rotary processing.Hope this helps

As I said I don't use tubes and don't do rotary processing and I rate my film at 125, so I guess I'm still looking. Sandy pointed me to the same excellent article, but for developing times it doesn't help me.

There has to be someone out there still using hangers besides me!

 

[Donald Miller]

My experience indicates that FP4 will support 125 EI. A development time of 9 1/2 - 10 minutes will get you into the ball park for printing on VC paper with a diffusion light source enlarger.

A great deal depends on your agitation procedures using a tank and also where you place your low values when determining your exposure.

 

[Eric Rose]

Thanks Don.