Change the Default Output Setting - Epson Scan

[paladin1420]

I'm scanning lots of old B&W negatives in my Epson V700 (using EpsonScan) and whenever I bring up the histogram adjustment window, the output level is always 200. I ususally change it to a higher setting so I have a bit more range in the resultant file. I cannot figure out any way to set this so it will default to a different number. Does anyone know of a way to do this? I just don't see one. I've even browsed through the registry settings, but don't see anything obvious.

Any help or suggestions are appreciated.

Thanks,

Paladin1420

 

[pschwart]

Set the output endpoints in the histogram page, then save the current setting (first pane at the top of the Epson Scan window).

I'm scanning lots of old B&W negatives in my Epson V700 (using EpsonScan) and whenever I bring up the histogram adjustment window, the output level is always 200. I ususally change it to a higher setting so I have a bit more range in the resultant file. I cannot figure out any way to set this so it will default to a different number. Does anyone know of a way to do this? I just don't see one. I've even browsed through the registry settings, but don't see anything obvious.

Any help or suggestions are appreciated.

Thanks,

Paladin1420

 

[paladin1420]

Thanks for the information. I will try that.