Cat Hair - Drying Film

[Thomas Bertilsson]

So, moving in with my girlfriend, and her two cats, has presented an interesting challenge. Cat hair.

I went to IKEA and picked up one of the 'DIMPA', which is a clothes cover that you hang in the closet. It fits four rolls of film comfortably, 24exp 35mm or 120. But, it's too short for 36exp 35mm. Is there a way to hang 36exp 35mm film by folding it in half, safely, like dip-and-dunk machines?

Grateful for tips.

- Thomas

 

[asp.artist]

Cut in half after processing? Or, if there's room just make a u shape with it.

 

[ic-racer]

Cut in half after processing? Or, if there's room just make a u shape with it.

That first suggestion could be messy, and the second suggestion not permanent. I'd just take it to the vet and have them deal with it in the usual way.

 

[Guillaume Zuili]

Don't dip the cats in photo-flo.
It doesn't work...

 

[bdial]

You can hang the film in a U shape, if necessary. Sometimes it helps to put a half or full twist in so that the bottom isn't just flat, or clip a hanger clip onto one side at the bottom. Otherwise the water can pool some in the U.
We have one cat, and I have a dedicated darkroom space, but the cat doesn't visit the darkroom so fur hasn't been a problem, FWIW. I guess she isn't a fan of photography.

 

[Thomas Bertilsson]

Forming a U with the film is something I'm a little afraid of. Is there a device in existence that allows for the 'bottom' of the U to be on the top?

I thought perhaps I could make hooks and hang the film from them in the sprocket holes, and then let the two ends of the film hang down. Ya thing that would work?

 

[MattKing]

Waste a frame near the middle of the roll, and then cut through that frame when you hang the roll (now in two parts) to dry.

Choose the wasted frame according to how you like to cut the roll after drying (e.g. if you cut your negs into strips of 5, you may want to waste number 16 or 21).

 

[Ronald Moravec]

Get a dog for the darkroom. Train it to follow their normal instincts, chase cats.

Not sure if dog hair sticks to film.

A good air filter goes a long way.

 

[mwdake]

I have 2 cats and a dog and fortunately never really had much problem with their hair on the film.

I put a little isopropyl alcohol in my final rinse to aid speedy drying and I live in a warm climate so my film dries fast.

I guess I could always give the cats a coat of varnish should their hair become a problem.

 

[Wade D]

The U thing with the open ends down sounds doable. A piece of coat hanger through the sprocket holes will work but rust would be an issue after a while. SS stiff wire would be better. I have 2 cats and even though they are NOT allowed in my darkroom the hair is so fine it still finds a way in.

 

[removed account4]

thomas

does your negative view holder take 5 across or 6 ?
just trim the bottom ( or top ) 5 or 6 frames ( or 10 ... 12 frames ) off and hang them next to the roll.
put the weighted holder or clothes pin on the sprocket holes to weigh it down
so it doesn't curl.

the film can be trimmed on the reel ...
no mess no problems.
unless of course the cats are in the tank ...

 

[Southern-Lights]

I've never developed film before, but what would be wrong with cutting a 36exp roll of film in between frames in like the middle? Or don't the frames show up until the film is dry?

 

[tkamiya]

Until the film is completely dry, the emulsion is soft and fragile. You wouldn't want to risk damaging it by handling it.

Yes, the frames are visible after the fixing stage.

 

[tkamiya]

How about constructing a gizmo with piece of plywood (small) and have paperclip hanger from 4 corners that will attach to the sporacket holes of film? After developing, guestimate half way point, hook two hangers, go to the other side and hook two more. The film will form an up-side-down U with gizmo at the top. That way, you won't be cutting the film, won't be handling it too much, and two side hanging from fold will be kept away from each other by the width of the plywood.

 

[lxdude]

That first suggestion could be messy, and the second suggestion not permanent. I'd just take it to the vet and have them deal with it in the usual way.

I assume you mean shaving them.

 

[jeroldharter]

Perhaps you could see how well the cats take to swimming on a good muskie lake?

 

[lxdude]

Just tell your GF, "It's the cats or me!". Then you'll have a place all by yourself.

 

[Mick Fagan]

I would use something like a wire clothes hanger, but at the bottom I would use a plastic pipe of about 10-15mm diameter.

I would then (carefully) load the film through the hoop with the emulsion facing outwards and just use two weighted film clips holding both ends and use a rubber band to hold them together.

Within reason, this is the method I've used in a dip and dunk machine, except we had weighted single film clips with a set of double teeth, absolute pain to use in complete darkness.

Mick.

Ps:- you will always find that the middle frame which was on the point of the curve, requires a glass holder in the enlarger.

 

[kozesluk]

I always had one cat at home, a small flat actually. I develop films in the bathroom (because I can close the door, make it absolutely dark and have running water there) and at the end after the last rinse I juse shower to spray hot water in the tub so the air in the place is more humid. Very humid air is the best way of eliminating the fur & dust problems at all, of course at the expense of 2-3x times slower drying. Another option is to shower myself before developing - and it's a lot more economical also
Just hang the film above the tub, get out of bathroom and close the door.

 

[Mick Fagan]

Lukas, do you use a wetting agent on yourself to save using a towel?

Mick.

 

[2F/2F]

I'd cut the film and hang from either end. Count frames before you cut, so it ends up jiving with whatever storage system you have. The U is a bad idea unless it is an upside down U.

Welcome to the world of fuzzy critters. I have three cats, and gave up long ago on ever having a totally clean workspace. Sometimes they come and print with me. I don't even bother to protest any more. No point in rebelling against thy feline masters, for thou shall never win.

I dry my film in a steamed-up shower stall, away from all feline activity.

 

[JOSarff]

Tom:

A few suggestions:

1 brush the cats outside or far away from the darkroom. I cuts shedding and they will love you for it.
2 do not let the cats in the darkroom.
3 an electrostatic air cleaner in the daqrkroom
4 a final everclear rinse should remove the water and make the film dry very quickly

Joe

 

[El Gringo]

I've got just the one cat. I've never had any problems with hair getting on the wet negs, however I use the shower to dry my negs like 2F/2F. It does somehow end up in the trays when I'm printing once in a while but it doesn't seem to cause any problems.

 

[Thomas Bertilsson]

Thanks for the input everyone. I think I know what I need to do now.

There are two cats in this household, and they can not be separated from the darkroom. The darkroom is basically a section of the basement that has not been screened off, and is a multi-purpose room with laundry, bike repair, cat litter boxes, workshop, etc.

I will continue to use the clothes cover, and I will cut the film in half (18 frames to each half, which works since my neg holders hold six strips of six frames each), and hang the film from the sprocket holes on stainless steel wire hooks (one on each side, and weighted down as normal. Should work well.

Thanks to you all for taking time!

- Thomas

 

[Changeling1]

Get a wire/metal grooming brush and groom the cats at least once a week. The wired brush will remove most of the loose hair that would otherwise end up on your film and everywhere else. The cats will also be less likely to ingest dangerous "fur-balls" while grooming themselves. Don't let the cats watch you hanging your film as they will immediately want to play with it. The Jobo film drying cabinet works quite well and can be purchased very cheaply these days. There's a cabinet for sheet film and roll film as well. The plastic cabinets can be easily stowed out of sight in between sessions.