Bought LOMO Anamorphic 35 nap2 3m 56/2 f:80-110 lens

[frobozz]

Dead Link Removed

Duncan,

Could you please check below list ? Do 35nap fit one of them ?


Our Basic Clamp Kit gives your Anamorphic lenses 3 standard sized (60mm, 58mm & 52mm) filter thread diameters & allows you to lock in a proper horizontal alignment! Mount & properly align a wide variety of lenses to cameras like the Canon 5D, 7D, t2i, 550D, 600D, t3i, 60D, 70D, Nikon D90, D610, D800, GH3, Black Magic Cameras, Red Cameras, Digital Bolex, etc. and 35mm adapters.

- Basic Clamp Kit: For Anamorphic lenses that have back end base smaller than 57mm. Lenses like the Sankor, Singer, Eiki, Kowa 16 series, Kowa 8Z and 16H, certain Bell & Howell attachments, Sun, Proskar, etc. (Pictured in photos 1 - 3)

- XL Clamp Kit: For larger Anamorphic lens attachments with a back end base that larger than 57mm in diameter and smaller than 76mm in diameter. The mounting thread size is a standard 72mm only. To use the XL Clamp on SLR lenses with front thread sizes other than 72mm, you'll need simple step-up or step-down rings found for a few dollars on ebay or in most camera shops. (Pictured in photos 4 - 5)

- Front Filter Clamp: For Aanamorphic lenses with a FRONT diameter smaller than 76mm. It will give compatible Anamorphic lenses a front filter diameter of 72mm for mounting standard size filters, like Polarizing and ND Fader Filters which are a must! (Pictured in photos 6 - 7)

- Basic Clamp Kit (Narrow version): The same as the basic clamp kit with the 60mm base, 52mm and 58mm rings included, but this kit comes with a shallower base for use with Anamorphic lenses that have a narrow back end base. This is good for some of the Bolex-Moller 1.5x lenses, Smaller Delft Anamorphic lenses, etc. (Pictured in photos 8 - 9)

- XL Front Filter Clamp (72mm filter thread size): For Aanamorphic lenses with a FRONT diameter smaller than 94mm. It will give compatible Anamorphic lenses a front filter diameter of 72mm for mounting standard size filters, like Polarizing and ND Fader Filters which are a must! (not yet pictured

I don't have my 35nap handy (in fact I'm not quite sure where it is at the moment...) but my memory is that it is MUCH larger than 76mm in diameter at the back end, so their XL Clamp Kit would still be too small. But there is an idea, based on their description of the Basic Clamp Kit - there were lots of anamorphic attachments made for 16mm projectors (they include several I have seen before in their list there, plus I have seen an actual Panavision anamorphic attachment before) and those would probably be much easier to deal with when using a smaller camera like you are talking about. I see a bunch on ebay right now, but they are all too expensive. (I also seem several more of the 35nap for sale too!)

Duncan

 

[Mustafa Umut Sarac]

Duncan,

I learned it is 104mm and mine is on the mail.

I wrote them via online forum and facebook but I found an excellent article and posted on articles. You can enjoy it. Hose clamps and rubber and screws. Thats all I need. I will make everything engineering from the lens , may be 3 weeks later.

Umut