Dead Link Removed
Duncan,
Could you please check below list ? Do 35nap fit one of them ?
Our Basic Clamp Kit gives your Anamorphic lenses 3 standard sized (60mm, 58mm & 52mm) filter thread diameters & allows you to lock in a proper horizontal alignment! Mount & properly align a wide variety of lenses to cameras like the Canon 5D, 7D, t2i, 550D, 600D, t3i, 60D, 70D, Nikon D90, D610, D800, GH3, Black Magic Cameras, Red Cameras, Digital Bolex, etc. and 35mm adapters.
- Basic Clamp Kit: For Anamorphic lenses that have back end base smaller than 57mm. Lenses like the Sankor, Singer, Eiki, Kowa 16 series, Kowa 8Z and 16H, certain Bell & Howell attachments, Sun, Proskar, etc. (Pictured in photos 1 - 3)
- XL Clamp Kit: For larger Anamorphic lens attachments with a back end base that larger than 57mm in diameter and smaller than 76mm in diameter. The mounting thread size is a standard 72mm only. To use the XL Clamp on SLR lenses with front thread sizes other than 72mm, you'll need simple step-up or step-down rings found for a few dollars on ebay or in most camera shops. (Pictured in photos 4 - 5)
- Front Filter Clamp: For Aanamorphic lenses with a FRONT diameter smaller than 76mm. It will give compatible Anamorphic lenses a front filter diameter of 72mm for mounting standard size filters, like Polarizing and ND Fader Filters which are a must! (Pictured in photos 6 - 7)
- Basic Clamp Kit (Narrow version): The same as the basic clamp kit with the 60mm base, 52mm and 58mm rings included, but this kit comes with a shallower base for use with Anamorphic lenses that have a narrow back end base. This is good for some of the Bolex-Moller 1.5x lenses, Smaller Delft Anamorphic lenses, etc. (Pictured in photos 8 - 9)
- XL Front Filter Clamp (72mm filter thread size): For Aanamorphic lenses with a FRONT diameter smaller than 94mm. It will give compatible Anamorphic lenses a front filter diameter of 72mm for mounting standard size filters, like Polarizing and ND Fader Filters which are a must! (not yet pictured