Bolex H8 Rex CLA

[ic-racer]

Started running slow and had some difficulty pulling some 100f rolls of Foma through the mechanism. It has been a while since I worked on this one. Time to open it up and see what is going on.

 

[ic-racer]

I removed the lenses. These screws need to come out.

 

[ic-racer]

Remove 4 screws on top of the finder. Close the light shade on the viewfinder.

 

[ic-racer]

4 screws need to be removed to release the viewfinder.

 

[ic-racer]

Remove this 6mm nut from inside. Removing the nut allows the turret stabilizer to be removed.

 

[ic-racer]

Remove the other three screws from the turret.

 

[ic-racer]

To remove the front. Make sure the film claws are out of the way. Set the shutter wide open and like this in the picture.

Lift up a little on the back (to free the variable shutter lever from its pin) and pull forward.

 

[ic-racer]

Loosen the screws for the handle (the ends sometimes get in the way).

 

[ic-racer]

Remove the five screws. Don't remove the ones with the "x."
Press in the film cutter to allow the innar mechanism to come out. You may have to turn it upside down and tap it on the table.

 

[ic-racer]

 

[ic-racer]

I took the film counter to keep it from getting damaged.

 

[ic-racer]

This is the governor. It is likely gummed up, causing slow and erratic speeds.

 

[ic-racer]

Some old goop around here.

This was cleaned and re-assembled with just a little moly grease.

 

[ic-racer]

One of the drive wheels was too high, causing loading problems.

 

[ic-racer]

The forward drive claw was not aligned with the center of the sprocket hole, so it was bent upward slightly.

 

[ic-racer]

Various rotating shafts were oiled, and gears lubed with grease. Some sliding components also got grease.

After packaging it back together I'm very impressed, it is my smoothest running Bolex.

 

[ic-racer]

All ready for some 100ft loads.

 

[foc]

Thank you for sharing. Your detailed photos make it look so easy.

 

[ic-racer]

 

[ic-racer]

Using an adapter made by SK Grimes, I was able to fit some wide angle adapters to the 5.5mm lens. Even though 5.5mm seems like it would be a wide lens, on regular 8mm format the angle of view of the 5.5mm lens is similar to a normal lens on any other camera.

 

[ic-racer]

 

[D_J_bolex_H8]

Various rotating shafts were oiled, and gears lubed with grease. Some sliding components also got grease.

After packaging it back together I'm very impressed, it is my smoothest running Bolex.

Do you ever do a cla for people or know a well known person that does it. I need mines lubed

 

[koraks]

Do you ever do a cla for people or know a well known person that does it. I need mines lubed

Welcome to Photrio!
If we can rephrase your question to "can anyone recommend a place to get my Bolex CLA'd", then it's OK to ask here. For direct questions asking people to sell you something, service something for you etc., please either use private messaging (as soon as you have access to this) and/or consider using the Classifieds section. We try to keep the forum focused on information exchange and restrict commercial activity to the Classifieds. Thanks for your understanding.

 

[jacques-tati]

Machst du jemals einen CLA für Leute oder kennst du eine bekannte Person, die das macht? Ich brauche meine gesc

Simon Wyss in der Schweiz