Beseler 45 Align

[CMoore]

I have the base level Front/Back on the counter top.
I put a piece of 1/8 inch aluminum sheet in the neg holder and it is level side to side.
The front is 1.8 inch lower than the back, but i cannot find the adjustment.
The manual says to remove Horizontal Lock item #26 and use the vertical adjust screw item #28 to adjust the front to back height.
Do you guys see either 26 or 28 on my enlargers.?
Thank You

http://imgur.com/kGsHIow
http://imgur.com/ZFVM7pl
http://imgur.com/ahzAnLF
http://imgur.com/EMIqdUa

 

[photog_ed]

I don't have the manual, but I can judge by comparing to my Beseler 45. In your last photo, The bolt and the arc-shaped hole it goes through must be item 26, and the nut on the opposite end from the bolt head is item 28.

HTH

Ed

 

[rolleiLeicafilm]

I do not have my manual in front of me and do not know which item numbers are given to these parts, however, the attached picture identifies how i adjust the front-to-rear alignment on my Beseler 45MXT. Hope this helps.

 

[CMoore]

Ahhhh.....Thank You Both