a 10-15 degree temperature change during photo-flo, will this have adverse effect?

[desi8888]

screwed up and forgot to adjust temp during final step (photo-flo), will this have adverse effect on the quality of the negs?
tx400/microdol.

 

[brucemuir]

I doubt you will see any effect.

Was the PF colder or warmer than the rest of the process.

 

[desi8888]

10-15 degrees colder.

 

[brucemuir]

I think you will be fine.
Some softer emulsion films like Efke or maybe Foma?? can reticulate if shocked too much.
Also if you used a fixer with hardener that will help 'toughen" the emulsion.

 

[desi8888]

I used kodak powder fixer.
thanks by the way!

 

[desi8888]

I was concerned about the grain.

 

[bdial]

Nothing past the developer stage will affect grain, though reticulation will produce a grainy sort of look.
A 10 -15 temperature drop is a lot, but probably won't be a problem for Kodak products as Bruce said.

 

[desi8888]

thank you all!

 

[nworth]

With TX, there will probably be no problem. Some non-hardened films (there a still a couple of these) could suffer reticulation.