Pupfish
Member
I recently had a Super Graphic in addition to two Meridians (a Model 45B and a prototype 45C). Never warmed up to the Super Graphic so I sold it. Reasons why include that it doesn't rack-focus with wide angles (no focusing on the inner rails, though a Crown offers this), and the hard to use front tilt lock-out. The rotating back is useful but not as useful as the rotating back + tilt and swing back moves on the Meridians.
Just not into shooting roll film on a 4x5. With the SG it was hard to see what was being framesd via the peep-sight and hoop viewfinder. Lot of back-swapping to use it with roll film for anything critical. At least in my case, the Graflok back didn't count for much.
Unmodified Meridian backs do allow use of Quickload/Readyload holders, and with a small spacer or a few washers, Grafmatics.
If you do decide on a Meridian, what you're likely to encounter in the used marketplace are a fair number of used Meridians showing up with butchered backs. These are attempts to either make them full Graflok backs, or else to have clearance to use with insert roll film holders (by grinding off the "ears" that are handholds for opening up the gape to insert a film holder). There never were many Meridian 45Bs (Total production run of ~1000, more than 60 years ago). They were considered rather collectible up until the past couple of years, so many of these modifications are recent and crude. Seems a shame but that's the state of things at this late date. If you do find a nice original one, with a Kalart rangefinder, it's quite as capable as all but the most recent Linhofs--albeit no RF cams-- but with longer lasting synthetic bellows that are likely as not to have survived light tight.
Just not into shooting roll film on a 4x5. With the SG it was hard to see what was being framesd via the peep-sight and hoop viewfinder. Lot of back-swapping to use it with roll film for anything critical. At least in my case, the Graflok back didn't count for much.
Unmodified Meridian backs do allow use of Quickload/Readyload holders, and with a small spacer or a few washers, Grafmatics.
If you do decide on a Meridian, what you're likely to encounter in the used marketplace are a fair number of used Meridians showing up with butchered backs. These are attempts to either make them full Graflok backs, or else to have clearance to use with insert roll film holders (by grinding off the "ears" that are handholds for opening up the gape to insert a film holder). There never were many Meridian 45Bs (Total production run of ~1000, more than 60 years ago). They were considered rather collectible up until the past couple of years, so many of these modifications are recent and crude. Seems a shame but that's the state of things at this late date. If you do find a nice original one, with a Kalart rangefinder, it's quite as capable as all but the most recent Linhofs--albeit no RF cams-- but with longer lasting synthetic bellows that are likely as not to have survived light tight.