Zone vi print washer leaking

dlarson · Jan 25, 2011

I just picked up a Zone Vi 20X24 print washer in great condition except that the drain valve on the bottom has a slow leak. Has anyone replaced or fixed this valve and if so with what. Is the hole threaded and if so do you know what size. Thanks.

Dave

Peter Schrager · Jan 25, 2011

I'm not sure about your valve but if you go to the boating store there is a product that will hold anything and can actually be applied underwater (name escapes me); hope this helps a little as it repaired my zone VI (non-valve)
Best, Peter

resummerfield · Jan 25, 2011

I have an 11x14 model, and the drain valve leaked, too. I replaced it with a brass ball valve from the home center. I can't remember the exact size, but it was a common size, probably 1/8-inch pipe thread. Unscrew the plastic valve and take it to the home center and match it up.

dlarson · Jan 25, 2011

I will take off the valve and see what I have. I like the ball valve suggestion. Thanks.

Zone vi print washer leaking

dlarson

Peter Schrager

resummerfield

dlarson

Privacy & Transparency

Privacy & Transparency