ig, you don't have to depend on someone else to get an idea of how film X behaves in developer Y etc... Get a grey card and load your camera with the film you want to test. Place the card in a place where it's evenly lit, preferably by daylight. Get a reading with the meter and focus your lens at infinity. Now make a series of exposures from 5 stops underxposed to 5 stops overexposed. There should only be the grey card in the frame(s). If you wish to have additional precision (thirds of a stop), by all means do it, but that makes sense for the extremes of the of the exposure range, for instance between 5 and 4 stops underexposure. Process the film, let it dry and then:
1) If you have a diffusion enlarger make a contact print of these strips, with the exposure needed for minimum time for maximum black though film base and a #2 filter.
2) If you have a condenser enlarger you'd better make enlargements of these frames, again for the minimum for maximum black through film base, with a #2 filter. Making a contact print with a #3 filter will probably get you close, but enlargements will give more precision. After all, that's why you bought that meter for, didn't you?
Now you can make an assessment and see what kind of results your equipment and technique will give, as long as you follow what you did in the test. If the results aren't what you'd have wished, you can repeat the test with different development for instance. In any case, everything is fine and dandy with development times etc proposed by manufacturers and anyone else out there, but it's your results that matter.
PS Keep in mind that you have quite a bit of overexposure latitude with negative films. Just because you see a totally white frame at the contact sheet, it doesn't mean that there's no information there at all, unless you've grossly overdeveloped.