What size inlet & outlet for Zone VI washer

[nsurit]

I have an 11 X 14 Zone VI archival washer which has lost its inlet and outlet elbows. The threaded part on the inlet is 3/8" and the dischage threaded part is 1". Can anyone tell me what size the original hose barb was on these fittings. I guess the other question might be, "Does it really matter." Thank you, Bill Barber

 

[AllenR]

Bill,

I just measured the fittings on my washer. The inlet hose barb is 3/8" and the outlet barb is 1". It really doesn't matter though, as long as they are large enough to allow sufficient flow in and out.

 

[nsurit]

Allen, thank you for your reply. Finding a nylon 1" elbow with a 1" barb is difficult to say the least. The 3/8" is a little easier, if you need 10 of them. Anyone have any specific ideas about "getting places?" Bill Barber