Watziss?

Rick A · Jun 28, 2011

I acquired this when I picked up my Jobo, was in with the processing tubes. I looked at it for awile, then tossed it back in the box. A few weeks later, I listed some Ilfochrome tubes here, and while looking up instructions for their use, I finally figured out what it was. You have a couple of clues already.

Can you figure it out?

Make your best guesses, then I'll show the rest of the photos and explain.

Zathras · Jun 28, 2011

Rick A said:
I acquired this when I picked up my Jobo, was in with the processing tubes. I looked at it for awile, then tossed it back in the box. A few weeks later, I listed some Ilfochrome tubes here, and while looking up instructions for their use, I finally figured out what it was. You have a couple of clues already.

Can you figure it out?

Make your best guesses, then I'll show the rest of the photos and explain.

It's an old 4x5 Cibachrome processing tube from way back when. Ilford marketed a 4x5 Cibachrome starter processing kit back in the late '70s to early '80s to let people try out the process at a relatively low price. The kit included paper, chems, the drum and i think a basic filter kit. If memory serves, the kit sold for about $21.95 US..

Mike

Rick A · Jun 29, 2011

Zathras said:
It's an old 4x5 Cibachrome processing tube from way back when. Ilford marketed a 4x5 Cibachrome starter processing kit back in the late '70s to early '80s to let people try out the process at a relatively low price. The kit included paper, chems, the drum and i think a basic filter kit. If memory serves, the kit sold for about $21.95 US..

Mike

You are correct! It's a two sheet, 4x5 processing drum. It uses a whopping 40ml of liquid to develope a pair of 4x5 sheets of film. I souped a pair of Delta 400 4x5's in Rodinal 1+50 and, except for an overlap mark on one negative, obtained perfectly developed film!

Here is what is inside, and the result. It is the most perfect pack-along processor I have ever found. Pour 40ml chems in the female end(holding upright), carefuly lay on side and roll back and forth on a counter. When step is complete, just hold upright over the sink and let the chems drain from the male end, while pouring fresh chems into the female end for the next step. The fresh chems are held inside the internal cup until the tube is laid on its side.

How ingenious!

Steve Smith · Jun 29, 2011

Would it work with 5x4 film?

Steve.

Rick A · Jun 29, 2011

It would if you shot in portrait mode only!

Steve Smith · Jun 29, 2011

Perhaps I should have read all of your post! Then I would have realised that you have already processed film with it - even if it is your strange US film which is rotated ninety degrees compared to ours!

Steve.

Rick A · Jun 29, 2011

Upon further study, you could use it, but only one sheet at a time, as you would have to insert the film the wrong direction to use.

Neal · Jun 29, 2011

Dear Rick A,

A small caution. Years ago I tried using one to develop film but the area where the cylinder transitions to the funnel was thin enough that light came through and fogged that area. I think it would have worked well in comparatively subdued light.

Neal Wydra

Rick A · Jun 29, 2011

Thanks for that tip. I used it in broad daylight in my kitchen the other afternoon, no problems(other than careless loading and film overlap).

mgb74 · Jun 29, 2011

I have a couple of these, though haven't tried it yet. I know it was for 4x5 film, but didn't know it was manufactured by/for Cibachrome. Essentially, it's BTZS tube's ancestor.

Rick A · Jun 29, 2011

Now it makes me think I should keep the Ilfochrome tubes and try developing film in them as well. This is a dandy one shot quick check tank. There is a huge difference between 40ml in this and 850ml for taco method in my big plastic tank, and 1.5l in the FR tank. I still like my Jobo for more than one or two negatives though. This certainly appeals to the cheapskate in me.

mwdake · Jun 29, 2011

I've got one of them somewhere but it is much bigger, 8x10 or 11x14.

akfreak · Jul 7, 2011

Well I replied to your other thread where you are going to thow these in if I bought the the other listed Items. Consider it sold, This is perfect for me. I use HC110 one shot and this is perfect. Please reply to your PM so I can pay you, AKf

Monito · Jul 7, 2011

Steve Smith said:
Would it work with 5x4 film? Steve.

Only if you use millilitres of fluid instead of ounces.

Sirius Glass · Jul 7, 2011

But would it work for 4x5 film, too??

vpwphoto · Jul 7, 2011

I have mine.. it was for Ciba 8x10 prints (or smaller). I to have done some film in it. Kinda neat to use.

akfreak · Jul 8, 2011

PM sent on the Ciba tubes thread where you offer these as part of the deal. I all take them, I have PMed you several times. I just want to cover my rear end. I need this stuff, Thanks AKf

akfreak · Jul 8, 2011

Il will take it as part of the Ciba tubes deal (there was a url link here which no longer exists)

akfreak · Jul 9, 2011

Payment sent

michaelbsc · Jul 9, 2011

Hey, I actually have one of those!

I'll give it a try.

Rick A · Jul 9, 2011

After trying it for a couple of times, you may only want to develope one sheet per time. I had a problem with two sheets, overlap lines showed from not being extra careful loading.

Watziss?

Rick A

Attachments

Zathras

Rick A

Attachments

Steve Smith

Rick A

Steve Smith

Rick A

Neal

Rick A

mgb74

Rick A

mwdake

akfreak

Monito

Sirius Glass

vpwphoto

akfreak

akfreak

akfreak

michaelbsc

Rick A

Watziss?

Attachments

Attachments

Privacy & Transparency

Privacy & Transparency