Viewing lights

[Adrian Twiss]

I am in the process of designing and building a new darkroom. Because of space considerations and need to have quite a lot of wall cupboards I intend to use an Anglepoise lamp as a viewing light. At maximum extension this light would sit about 22 inches above the print. Does any member have any opinions about the wattage of bulb I should use. I was thinking about 40watts

 

[Nige]

I don't know what a "Anglepoise lamp" is.. but at 22", 40W would be bordering on to much I'd think if it's a bare bulb. I've got a bare 60W on the roof and ideally it could be a fraction brighter, but a 100Wer is too much. (Haven't got a 75W to try.. must buy one one day)

 

[djklmnop]

I bought a cheap lamphead swivel/tilt which mounts on to a wall shelf, and I attach a 25 Watt bulb to it (tungsten). The low wattage helps to combat dry-down time and will give a good impresion of how things may look when dried.

Andy

 

[baronfoxx]

HI
I use a 60watt blue daylight bulb about 5ft above the worktop and it works fine , being daylight it is very usefull in judging colour prints
you can get the bulbs from Novadarkroom and firstcall