uv vacuum or contact frame?

coigach

Member
Joined
May 23, 2006
Messages
1,593
Location
Scotland
Format
Multi Format
Am wanting to dip my toe into the world of pt / pd printing and wanted to ask a basic question. If it's a daft one, please be gentle....

I'm a member of a local artists print studio where I have full access to lots of great facilities. At the studio I work on the hybrid polymer photogravure process. The studio has a wonderful large vacuum uv box which I use for exposing polymer plates.

Rather than buying a contact frame for my intial dip into pt / pd printing, could I / would I be better using this uv vacuum box at the studio? (Am looking at starting with smaller prints intially then working upwards as I (hopefully!) become more proficient).

Thanks for your help,
Gavin
 

jeffreyg

Subscriber
Joined
Jun 12, 2008
Messages
2,641
Location
florida
Format
Medium Format
Gavin,

Since you are testing the waters why not use the equipment available? I don't know what arrangements that studio has but it can be rather time consuming to make pt/pd prints so if your time allowed with the vacuum uv box is restricted that could be a problem. I have never used a vacuum box. I use a printing frame with no problems. Actually when I started pt/pd printing I bought a starter kit from Bostick and Sullivan and used the sun as a light source which in itself had limitations but I'm in sunny south Florida. Once I was sure I wanted to continue with that medium I bought a UV light box and a larger printing frame. I see no difference in the prints exposed with the sun and those with the light box. Using the light box is much more convenient --- print any time of day in any weather in the ac and no mosquitoes.

Enjoy, there is nothing like a pt/pd print.

http://www.jeffreyglasser.com/
 

artonpaper

Subscriber
Joined
Aug 7, 2007
Messages
336
Location
Staten Island, New York
Format
Multi Format
The vacuum frame should work fine and I assume it has a light source. Sometimes, very seldom actually, vacuum frames can cause an uneveness in Pt/Pd prints due to moisture retained in the paper. That moister gets forced out along the grooves that are typically found in the rubber pad that comes in the vacuum frame. A piece of matte board under the print, black if possible, will usually cure that problem. But, just try one and see what happens. It will more than likely work fine.
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…