Translyte rc print dryer

Hi, I’ve got a Translyte rc printer, I’m unable to find any info online in regards to using this type of hot air rack rc dryer, any tips on best practice to keep prints flat would be very much appreciated, for example should the prints be partially dried for short time like 5 minutes then finished off to press under weights or fully dryed for longer?
Thank you for any advice in advance
sorry but just to clarify this printer has flat racks with warm air blown through it. It is for Rc paper not fiber based paper

When I was in Photrio about lunchtime I thought I saw your post, Benoit and could have sworn that you has some replies but if this was the case they have disappeared

A bit puzzling

pentaxuser

pentaxuser said:

When I was in Photrio about lunchtime I thought I saw your post, Benoit and could have sworn that you has some replies but if this was the case they have disappeared

A bit puzzling

pentaxuser

Click to expand...

Hi I’m new to this forum I have just also joined fadu don’t yet know quite how to navigate them yet, thanks for informing me I shall look into it
regards Ben

Those of us who sometimes sign in to more than one photography oriented website sometimes can't remember which site has what
Try FADU - I think you may find what you remember seeing there .

MattKing said:

Those of us who sometimes sign in to more than one photography oriented website sometimes can't remember which site has what
Try FADU - I think you may find what you remember seeing there .

Click to expand...

Hi Matt
Thank you for the advice

Benoitg said:

Hi Matt
Thank you for the advice

Click to expand...

I was actually responding to pentaxuser, because I happened to have seen your thread on FADU asking a similar question, and getting a few more responses