I've never tried taping them together but I do routinely develop two 120s on a single Paterson spiral. Load the first one and then carefully push it onto the spiral as far as it will go, then load the second. Load it until the end is just past the ball bearing. Never had a problem.
I first load the first film the normal way but I keep on winding the reel until the film goes a quarter of the reels diameter past the reels start. Then, I put the second film through the reels start and wind it until it touches the first films end. I tape them together with a small piece (around 1-1,5 cm) of electrical insulating tape..
Separate the first roll completely from [...] Takes way longer to write than do.
I've never tried taping them together but I do routinely develop two 120s on a single Paterson spiral. Load the first one and then carefully push it onto the spiral as far as it will go, then load the second. Load it until the end is just past the ball bearing. Never had a problem.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?