Super Graphic Lens Board

I have a Super Graphic that needs a shutter cleaning. When attempting to remove the lens board there seem to be some wire connections in the lower left corner (my left, facing the camera). I assume these are for the flash or the solenoid shutter release or both. I am loath to pull on them too hard. How do these disconnect to fully remove the lens board?

Please post a picture of the board and wires as this is not factory standard.

Thuggins... are you talking about a pair of metal wire contacts between the board and the bi-post flash terminals? Sometimes exposed; other times covered by a plastic cover? A pic would help.

see pages 5 and 6:

https://www.pacificrimcamera.com/rl/00612/00612.pdf

if so, see page 9. The two knurled screws release those flash connectors.