Hi!
I'm new to darkroom printing and recently picked up a 23Ciii condenser enlarger. I have two enlarging lenses and jam nuts but only one lens board at the moment. I'd like to swap lenses, using the current board now and a second one when I get it, but I'm having trouble removing the board from the head.
From reading online I was under the impression I needed to press the board up and slide it back to remove it, but it feels like it's really strongly attached. Can anyone share some advice on how this is supposed to work and what I might be doing wrong?
Thank you!
-Will
I'm new to darkroom printing and recently picked up a 23Ciii condenser enlarger. I have two enlarging lenses and jam nuts but only one lens board at the moment. I'd like to swap lenses, using the current board now and a second one when I get it, but I'm having trouble removing the board from the head.
From reading online I was under the impression I needed to press the board up and slide it back to remove it, but it feels like it's really strongly attached. Can anyone share some advice on how this is supposed to work and what I might be doing wrong?
Thank you!
-Will