Rolleiflex 3.5f parts diagram

[Toffle]

Hi folks;
My Rollieflex 3.5f is missing missing the tiny nut/ring that screws onto the flash connector socket and holds the flash connector release lever in place. It's very small, very obscure, and probably not very expensive. (I hope )
If anyone knows the part number for this, or has seen such a part or knows where to source it, I would greatly appreciate it.

Cheers,

 

[luvcameras]

Try Fleenor (harry@rolleirepairs.com) or Krikor (http://www.krimarphoto.com)

Of this list http://www.stutterheim.nl/rolleigraphy/rolleiflex_service.htm

Dan

 

[Toffle]

Thanks, Dan. My first instinct was to contact Harry, but I was hoping to find the part number before I asked him.. I suppose of all people, he would be the one to ask.

Cheers,

 

[ic-racer]

04474.00.2 KONTAKTVORSCHRAUBRING (CONTACT RETAINING RING)
The only one I know of is on my camera

 

[Toffle]

04474.00.2 KONTAKTVORSCHRAUBRING (CONTACT RETAINING RING)
The only one I know of is on my camera

Thanks, but I won't be needing that one...
This is not an emergency situation; I do have a ring of the correct thread and diameter, but it lacks the offset that allows the original Rolleiflex part to screw fully into place. It's not great, but at least it's not falling apart.

Well, now I have a part number... thanks very much. I've already emailed Harry, so I'll send a follow up with the number.

cheers

 

[dpurdy]

http://www.collectcamera.com/colcam/products/rolleispare.htm

This place sells parts and have about a million of them on line. You could just get hold of him and ask.
Dennis