Removing Zone VI Cold light Head

[Kloppervok]

I am in the process of installing a dichroic head in a 23CII, but i can't figure out how to disconnect the power supply from the cold head that it came with!

The connection looks like the following images.
Dead Link Removed
Dead Link Removed

I have no idea what to do with this connection. Both ends unscrew, but they just seem like caps to protect the stripping. The middle bridge has a 'press' instruction, but no matter how hard i try (not too hard!), it's incompressible.

Can anyone give me a hint?

 

[nsurit]

Have you tried pushing the two parts together and then twisting them? Bill Barber

 

[Kloppervok]

You can kind of see the damage and scuffing in the lower image where i took a vise to it. I can't seem to make anything budge here.

 

[Rick A]

The plastic is old and has lost its 'plasticity'. You will probably have to use a screw driver to press in the area marked 'press', and pry them apart. Unfortunatly, it may break the tab, but that may be your only recourse. I have run into this problem many times servicing my 1995 automobile. over the life of the part, it is subjected to uv, and other oxidizing elements, and becomes brittle. I'm sorry I dont have any other suggestions for you.

Rick

 

[Dave Pritchard]

I am not familiar with this connector, so sorry I can't help. I do work with lots of different connectors. I agree that this one looks as if it will have to be damaged to get it unmated. Can you just leave it together? If you had the mating connector on your new dicroic head, I expect you would have mentioned it. Otherwise, a picture of any mating connector would help to understand how this one unlatches.

 

[Kloppervok]

Thank you for the suggestion Rick. It took a little while, but with my flat head screw driver, i separated the connection. Though the damage was minimal, i don't think i sheared anything, so hopefully the head can be safely stored for later use.

Dead Link Removed