- Joined
- Jan 1, 2006
- Messages
- 3
- Format
- Med. Format Pan
Hello all,
Today I have been doing some Albumen printing. I could not get hot water and the fixer was very cold, I would say around 15ºC. I was using two baths of 15% “Hypo” and as the temperature was quite low, I gave the print 5 min in each baths. The print looked like it was fine but as by experience, I know badly fixed Albumens can start getting yellow highlights even after a few days, I was thinking to re fix the print tomorrow. I have never tried before. It would somehow be a bad idea?, can be done?.
Any advice will be much appreciated.
Thanks
Javier
Today I have been doing some Albumen printing. I could not get hot water and the fixer was very cold, I would say around 15ºC. I was using two baths of 15% “Hypo” and as the temperature was quite low, I gave the print 5 min in each baths. The print looked like it was fine but as by experience, I know badly fixed Albumens can start getting yellow highlights even after a few days, I was thinking to re fix the print tomorrow. I have never tried before. It would somehow be a bad idea?, can be done?.
Any advice will be much appreciated.
Thanks
Javier