Quick Hassy Question???

Tyndall Bruce

A
Tyndall Bruce

  • 0
  • 0
  • 29
TEXTURES

A
TEXTURES

  • 4
  • 0
  • 56
Small Craft Club

A
Small Craft Club

  • 2
  • 0
  • 52
RED FILTER

A
RED FILTER

  • 1
  • 0
  • 45
The Small Craft Club

A
The Small Craft Club

  • 3
  • 0
  • 52

Recent Classifieds

Forum statistics

Threads
198,903
Messages
2,782,790
Members
99,743
Latest member
HypnoRospo
Recent bookmarks
0

nyoung

Member
Joined
Dec 10, 2006
Messages
388
Format
Medium Format
GAS is setting in and I'm being tempted by a 501c with an 80 and a film back.
How is the 501 different from the 500cm etc.?
Better? Worse?
 

Q.G.

Member
Joined
Jul 23, 2007
Messages
5,535
Location
Netherlands
Format
Medium Format
Quick question, longish answer, trying to keep it compact:

Compared to the 500 C/M, it is almost not different at all.
The 500 C/M has a detachable wind knob/crank. The 501 C hasn't.
The 500 C/M has a body ready signal window. The 501 C hasn't.
The 500 C/M has a locking lever around the shutter release button. The 501 C hasn't.
The 500 C/M has the old style tripod foot, the 501 C has the new style foot (still fits the old quick couplings, not the other way round).
The 501 C also has the new style two ridge support bottom. The 500 C/M does not.

Apart from what the older camera may (!) have experienced to make it worse, neither of the two is better or worse than the other.


The "etc." bit of your question requires a really long answer.
But quickly, limiting the list to functional features that really make a difference:

- The 500 C/M replaced the original 500 C.
It has user changeable focussing screens (the 500 C had a fixed screen).

- The 503 CX replaced the 500 C/M. It has a sensor built-in that can be hooked up to flash units through an adapter to provide TTL OTF flash metering.
It also came with the Acute Matte screen: brighter, but not really better. Screens can be changed very easily. So do not trust that a camera has a certain type of screen in it based on the camera type alone. Always check!

- The 503 CXi replaced the 503 CX.
It differs from the 503 CX in that it has a different wind crank mount. Not yet available when this camera was introduced, so we did not have a clue what this change was for, but it means the 503 CXi can be used with the Winder CW.

- The 503 CW replaced the 503 CXi.
It differs from the CXi in that it has a bigger mirror. The older cameras all have a mirror that is a bit too short, and causes viewfinder vignetting with longer lenses and when using extension (tubes, bellows). This only affects the viewfinder image, and is something you get used to.
The mirror was made too short to make sure it would not hit the rear element of the 80 mm lens when swinging up. The larger mirror in the CW avoids the lens by moving backwards while moving up.


The 501 C and 501 CM are a separate line, also branching off the 500 C - 500 C/M line.
- The 501 C is described above. Basically, a 500 C/M without a few minor features.
- The 501 CM is a 501 C with the larger mirror.


They are all (!) equal in quality.
No single model is better or worse than any other. No model to prefer or avoid for any other reason than the extra feature it may have.
 
Last edited by a moderator:

Anscojohn

Subscriber
Joined
Dec 31, 2006
Messages
2,704
Format
Medium Format
Quick question, longish answer, trying to keep it compact:

-No single model is better or worse than any other. No model to prefer or avoid for any other reason than the extra feature it may have.

Quick question to an obvious expert: There is a proper way to put the dark slide in the magazine on the 500C backs, correct? I cannot figure out the directions translated from Swedish, viz:
"...with its rolled-over handle-edge facing toward the camera front."
 

Q.G.

Member
Joined
Jul 23, 2007
Messages
5,535
Location
Netherlands
Format
Medium Format
The correct way presents itself when you try to remove the insert from the magazine with the slide inserted.

Slide.jpg


Do it the wrong way round, and you'll pull the slide out at the same time.


Hasselblads are simple things.
That's why the manuals are so thin*. And the majority of the things that are in there are so obvious that you really do not need them to be in a manual.
And that's also why it's so very easy to be an expert: you, John, will have noticed this handle thingy long ago, and never thought twice about it. Just done it right instinctively.
It's when they start putting such simple things in manuals that we begin to doubt that they really are as simple as we know them to be. Why else put them in a manual, right? But they are! :wink:

*I once gave a flippant explanation for the "M" in the Hasselblad type name as standing for "Manual", being that since the Hasselblads are that, you do not need one.
As it turned out, compared to the 500+ pages manuals that 'simple' consumer grade DSLRs of today need to explain their raison d'être, not so flippant after all.
 
Last edited by a moderator:

Sirius Glass

Subscriber
Joined
Jan 18, 2007
Messages
50,372
Location
Southern California
Format
Multi Format
Thank you. This is a frequently asked question.

Steve
 

Anscojohn

Subscriber
Joined
Dec 31, 2006
Messages
2,704
Format
Medium Format
Thanks, Q. Now I understand.
 
OP
OP

nyoung

Member
Joined
Dec 10, 2006
Messages
388
Format
Medium Format
Thanks to all for your expertise. I could have looked it all up, I suppose, but GAS requires quick response.
 
Photrio.com contains affiliate links to products. We may receive a commission for purchases made through these links.
To read our full affiliate disclosure statement please click Here.

PHOTRIO PARTNERS EQUALLY FUNDING OUR COMMUNITY:



Ilford ADOX Freestyle Photographic Stearman Press Weldon Color Lab Blue Moon Camera & Machine
Top Bottom