I've been trying to experiment with different ways of using Farmer's Reducer. Today I was playing with applying just the stock Ferricyanide part of Farmer's Reducer to a print with a q-tip, then rinsing and placing in a fixer bath.
However, when I applied the stock Ferri, without any further dilution to the paper, the bleaching started immediately.
Is this an indication that I have not adequately washed the fixer from the print? I was expecting nothing to happen until I put the print back into the fixer.
However, when I applied the stock Ferri, without any further dilution to the paper, the bleaching started immediately.
Is this an indication that I have not adequately washed the fixer from the print? I was expecting nothing to happen until I put the print back into the fixer.