Krockmitaine
Allowing Ads
Hello you all,
I need some help to fix a problem that I'm experiencing with my machine
This came up last week when I powered the ATL to process a few rolls of C-41. The last time I used it, it was for developping C-41 so I was using the same program. But when I wanted to tweak the developper's development time, to my surprise I noticed that I could no longer access the SET MODE to edit the configuration. Whatever the number that I press when I'm on the SET MODE, I receive the message "Code No.: invalid!" before the program proceed to completion.
Also, there another problem that may or may not be related; the upper water level detector does'nt work anymore and the water feed is always on and reaches the overflow level before draining into the sink. But if a do a reset the water feed turns off.
From what I've read, I think there's two possible avenues that I can try but I need guidance: flash the EEPROM to reset to the factory setting or disconnect the battery. Any other solutions?
Marc
I need some help to fix a problem that I'm experiencing with my machine
This came up last week when I powered the ATL to process a few rolls of C-41. The last time I used it, it was for developping C-41 so I was using the same program. But when I wanted to tweak the developper's development time, to my surprise I noticed that I could no longer access the SET MODE to edit the configuration. Whatever the number that I press when I'm on the SET MODE, I receive the message "Code No.: invalid!" before the program proceed to completion.
Also, there another problem that may or may not be related; the upper water level detector does'nt work anymore and the water feed is always on and reaches the overflow level before draining into the sink. But if a do a reset the water feed turns off.
From what I've read, I think there's two possible avenues that I can try but I need guidance: flash the EEPROM to reset to the factory setting or disconnect the battery. Any other solutions?
Marc